Hp Laserjet 57 Service
Replace DC controller. Home | Error Codes | Hp Printers | Toner Cartridges | Hp Printer Accessories | Hp Plotters Copyright © 2011 Advanced Laser Services, Inc. Tell me and maybe I can help. Same as error 51. 2686/D Only: 1. controller board.HP LASER PRINTER 8100, 8150 ERROR 57.51. this contact form
At least one of two tabs must be present. 3. Replace optional I/O card. 43 OPT INTERFACE 1. b. HP LASER PRINTERS 4, 5, 4L, 5P 1. http://www.fixyourownprinter.com/posts/9213
Prev12Next » Not finding what you are looking for? I hate to just keep throwing parts at it until it works. Resend activation? The fan 3 or the formatter fan has a error.2.
What I do first is check the gears for any obstruction. Bad registration sensor or bad fuser exit sensor. Obstruction in paper path. 2. Thanks and keep up the good work.
Replace PostScript ROMs. Fan error.One of the cooling fans is bad. 2. The only thing that I did was disconnect the printer because I had to switch offices. http://printertechsforum.com/forum/showthread.php?2799-LaserJet-4-57-Service-amp-57-Fuser-Messages IIISi/4Si Only: 1.
- Replace the D.C.
- mary is online now What does 57 Service mean in my HP LazerJet 4 printer screen This answer was rated: ★ ★ ★ ★ ★ What does "57 Service" mean
- Powered by vBulletin™Copyright © 2016 vBulletin Solutions, Inc.
- Change the D.C.
- Replace if either is bad. 4.
- No toner cartridge installed. 2.
- I bought a 11/24/2016 11/24/2016 Richard I cannot get into my computer, It is a MacBook air, Ye,I 11/24/2016 11/24/2016 Dustin I can't write in the box, it won't take any
Top cover open. 2. weblink Fan operation occurs only during power up or during a print job.2. Plunger missing on top cover. 2. Service manual says this should be “about 220 K ohms +/- 40 K ohms.” Do these values mean that the old fuser was probably OK?
Yes, they are sometime lazy, but these EOL printer manuals is hard to find. Replace Parallel interface 5. Wht does that mean? http://technewsonline.net/hp-laserjet/79-service-error-hp-laserjet-pro-200.html Check paper feed roller.
I then installed the new fuser and after waiting ten minutes, powered up. The toner cartridge is OK because it has been inserted during a successful motor self test. I'll let you all know if I find the source of the problem.
Printer will work fine without it.
A sub cooling fan (FM2) error has occurred. Paper Control PCA malfunction. 3. See error 51. I never mentioned the manual, I know it's hard to find.
Check that nothing is hindering or blocking the fan. 4. Replace Laser Diode Assembly. 3. For LJ III, IIID, IIIP, IIISi/4Si with 1 MB extra memory, enable page protect. 22 ERROR/ I/O CONFIG ERROR 1. Fan error.One of the cooling fans is bad. 2.
First Time Here? This error can be caused by Paper Feed problems. 41.1 or 2 Error or 41.3 Error All Printers There is a paper multifeed or the wrong size of paper is being Defective Interlock Switch Assembly. 4/4M/4+/4M+ Only: 1. Listen for the Main Motor.
HP COLOR LASER PRINTER 4500, 4550 ERROR 57.21. Question about HP Printers & Copiers 1 Answer Gettining error 57.03 in hp laserjet 5200 printer ...Service Messages: 57.01.00 57.02.00 57.03.00 57.04.00 Required Action A fan motor failure occurred. Bad Fuser Safety PCA. (P/N RG1-0208-030.) Note 2686A/D: Short resistor R250 on the DC Controller to bypass error 50 time delay.