Home > Hp Deskjet > Hp Deskjet 5550 Printer Problems

Hp Deskjet 5550 Printer Problems

Contents

While holding the Power button, press the Resume button () four times. Figure : Close the cartridge latch Close the top cover. by unknown on Nov 29, 2005 at 10:44pm Add comment Please sign in to comment 0 Good afternoon,My principal has a 5550 that just stopped working. Reconnect the USB cable, and then try to print again. Check This Out

Insert the duplexer into the rear of the product, and then push it forward until it snaps into place. Best buy wants as much as a new printer and hp says thats the only way to fix it is to take it there. Hello all, I'm hoping you'll be able to help me with my problem. If the issue persists, continue with the next solution. http://h20564.www2.hp.com/hpsc/doc/public/display?docId=c00035263

Hp Deskjet 5550 Printer Problems

by Anonymous on Apr 2, 2006 at 6:32am Add comment Please sign in to comment 0 My HP 5550 is printing a large grey rectangle over the top of my photos Could you tell me what you did to fix it? Figure 40: Insert paper into the tray Move the paper width guide inward until it rests against the edge of the paper. by Jeremy1988 on Oct 10, 2005 at 6:46pm Add comment Please sign in to comment 1 Hello.

  • The product is on and ready for printing.
  • If you see this problem, go to Control Panel -> System -> Advanced -> Performance Settings -> Data Execution Prevention and then check the radio button next to "Turn on DEP
  • Insert the door into the rear of the product, and then turn the door latch clockwise to secure the door in place.
  • Solution one: Wait for the print job to complete Wait while the product prepares the print job.
  • Press the Power button () to turn on the product.
  • A while ago I noticrd that when prining from the PC (2K) that only a few lines were prined at which point the printing just stopped and the paper remained in
  • Step one: Reset the printer Press the Power button () to turn on the product.
  • Apply a moderate amount of pressure to remove any dust or dirt buildup.

If the carriage is stuck in the middle of the product, move the carriage to the right side of the product. Touching these parts can result in clogs, ink failure, and bad electrical connections. If the product does not turn on by itself, press the Power button () to turn it on. Hp Deskjet 5550 Manual So I wiggled it - it wouldn't move right but I did shove it left, and it then started responding and slid right over to the left and back over to

We can't seem to print anything... :( all three lights are blinking... ): please advise. I had just bought another $24 blk cartridge because I couldn't eliminate the blinking light with a refill cartridge. By continuing to browse our site you agree to our use of data and cookies.Tell me more | Cookie Preferences Partially Powered By Products Found At Lampwrights.com Login|Contact Us Printers http://h30434.www3.hp.com/t5/Inkjet-Printing/deskjet-5550-resume-amp-power-lights-blinking/td-p/931543 by Stephen on Dec 20, 2006 at 6:22pm Add comment Please sign in to comment 0 I did a really stupid thing one day when the printer was printing it just

As failure kept reoccurring I finally resorted to wiping both the cartridge and the contacts in the computer with a clean dry cotton cloth. Hp Deskjet 5550 Troubleshooting Guide Issue: The Power light is on and the Print Cartridge light blinks In this error condition, the following light pattern displays on the product control panel and a message might display There is no error message other than "the document failed to print, etc." Once i press the button next to the flashing light, the printer feeds the paper all the way Remove the paper slowly.

Hp Deskjet 5550 Not Printing

Gently remove the plastic cover that is over the spot sesor. http://resetprinters.com/resetting-the-hp-deskjet-5550-to-fix-common-printer-issues/ Figure : Remove paper from the front of the product Reconnect the power cord to the rear of the product. Hp Deskjet 5550 Printer Problems How to print a self-test report Make sure that plain white paper is loaded in the input tray. Hp 5550 Print Cartridge Status Light Is Flashing Raise the cartridge latch.

by Stephen on Mar 1, 2006 at 1:15pm Add comment Please sign in to comment 2 When you run a Tap-4 test on a 5550 it prints a page with it's his comment is here Figure 85: Reinsert the cartridge Close the cartridge latch. I have tried it with & w/o cartridges installed. Once reported, our moderators will be notified and the post will be reviewed. Hp Deskjet 5550 Printer Driver

If the test page does not print, continue with the next solution. I've reinstalled driver and powered on and off multiple times. The tri-color cartridge goes in the left carriage slot. this contact form But it don't kick the paper out now, so if I am printing more then one paper, it all snags up together, so I have to manually move the printed paper

I suggest that you email him for the particulars of his work-around. Hp Deskjet 5550 All Lights Blinking This feature helps to avoid wasting ink and paper if the paper is not what you expected. Use the icons to determine the cartridge issue.

This is Frustrating thanks for your time.

If the carriage is stuck on the right side of the product, move the carriage to the left side of the product. Disconnect the power cord from the rear of the product. If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. Hp Deskjet 5550 Reset Open the top cover on the product.

Cancel Print / Help" )When I press the resume button on the printer, it pulls the page back slightly then spits it out blank and prints the actual document with no Are there any other sensors that may cause it not to print? by Stephen on Dec 4, 2006 at 7:51am Add comment Please sign in to comment Could you tell me where you obtained this part? navigate here Issue: The Power light blinks In this normal condition, the following light pattern displays on the product control panel: Print Cartridge status light: Off Resume light: Off Power light: Blinking Figure

Figure : The Tri-color Cartridge Low-ink icon Cause The tri-color cartridge is low on ink. Can I glue the broken piece back in place? I cannot move the cartridge manually from that spot. Step one: Remove the cartridge Press the Power button () to turn on the product.

If the issue persists, continue with the next solution. Store the paper in a dry, cool place. Figure 50: Paper feed rollers Locate the paper pick roller. Disconnect the power cord from the rear of the product.

caution: If the paper tears when you remove it from the rollers, check the rollers for torn pieces of paper that might remain inside the product. The cartridge light is still blinking. Solution four: Adjust the print settings The product might not pick up paper if the paper size and type in the paper tray do not match the size and type settings Could it be XP SP2?

Follow the on-screen instructions to order new cartridges or check cartridge compatibility with your printer. Disconnect the USB cable from the rear of the product. Solution No action is required. Gather the following materials: A clean, lint-free cloth, or any cloth that will not come apart or leave fibers Distilled, filtered, or bottled water (tap water might damage the product) A

Step one: Clean the paper rollers Your product has either a rear access door, or a duplexer. Follow these steps to perform a reset. I had exactly this problem, or rather, my parents had, and of course they called me (300 miles away) to fix the problem over the phone.Thanks a million for posting your Figure : Remove the cartridge Step two: Insert a new cartridge Follow these steps to insert a new cartridge.