Hp Deskjet 5550 Blinking Ink Light
Figure : Attach the rear access door and secure the door latch Method two: Remove and reattach the two-sided printing accessory (duplexer) Remove the duplexer. I would like to know if i can do this and if i can. Wait until the carriage is idle and silent before proceeding. BE LUCKY T.CXXX XXXXXXXXXX - Anonymous 0 The little plastic piece on the right is the switch that tells the printer the cover is open. http://technewsonline.net/hp-deskjet/hp-deskjet-1010-blinking-power-light.html
Hp Deskjet 5550 Blinking Ink Light
Step two: Print a self-test report Print a self-test report to make sure that the hardware functions correctly. Press the Power button () to turn on the product. I spent many hours on the phone with an HP technician and paid the obsene amount of money, since my warranty had run out, only to have them not help me If the test page does not print, continue with the next solution.
Step two: Clear the paper jam from the rear of the printer Your product has either a rear access door or a duplexer. NOTE: Use a flashlight to thoroughly check the rollers and wheels for torn pieces of paper that might remain inside the product. I read over a lot of the posts concerning the power light and resume light blinking at the same time and the printer being nonresponsive. Hp Deskjet 5550 Troubleshooting Guide Apply a moderate amount of pressure to remove any dust or dirt buildup.
Follow the on-screen instructions to order new cartridges or check cartridge compatibility with your printer. Hp Deskjet 5550 Printer Driver Remove the new cartridge from its package, and then carefully remove the protective tape. by unknown on May 20, 2007 at 9:58pm Add comment Please sign in to comment 0 Here's another site with instructions:http://www.misterinkjet.com/hpreset.htm by Anonymous on May 21, 2007 at 6:55am Add comment Any ideas?
Press the swab against the paper pick roller, and then rotate the roller upward with your fingers. Hp Deskjet 5550 All Lights Blinking Remove the rear access door. But here's an idea. I wonder why i turned it off.
Hp Deskjet 5550 Printer Driver
I'm using Windows 7 and open office and so far had no problem with the printer at all. here How to use the solutions in this document To resolve the issue, try each solution in this document, and then use the steps in this section to print a self-test report. Hp Deskjet 5550 Blinking Ink Light by irmaly / October 1, 2016 11:56 AM PDT In reply to: HP DeskJet 5550 printer wont recognize new HP ink cartridge I want to thank everyone for the little paper Hp Deskjet 5550 Manual It worked like a charm.
Any ideas out there? his comment is here Wait 15 seconds. Choose the Advanced panel. I think this problem should be documented.Thank you so much!! Hp 5550 Print Cartridge Status Light Is Flashing
Apply a moderate amount of pressure to remove any dust or dirt buildup. While holding the Power button, press the Resume button () four times. I have the printer mentioned above, and it has gone crazy. this contact form Figure 96: Close the cartridge latch Close the top cover.
When I turn on the printer, it makes a sound as if it is trying to pull the carriage back in. Hp 5550 Deskjet Printer Troubleshooting I opened the top door which centered the cartridge carriage so I could pull out and reinsert the cartridges. Thanks.-----Im trying to help a friend with his deskjet 5550...The drivers wont work, it prints the test print.
Solution one: Wait for the print job to complete Wait while the product prepares the print job.
Disconnect the USB cable from the rear of the product. Click OK, and then click OK again to print the document. by unknown on Sep 7, 2005 at 2:28am Add comment Please sign in to comment 0 Thank You.I have spent literally days trying to figure out what was wrong.I was about Hp 5550 Blinking Lights I pulled the paper out and then tryed to print again but the orange light and power button were flashing now it just makes a noise like it is trying to
Visit HP SureSupply to check ink or toner cartridge compatibility, or purchase replacement cartridges. Blinking lights appear on the printer. The yellow arrow points to the Black Cartridge Low-ink icon. navigate here Step four: Make sure that the carriage can move freely Press the Power button () to turn on the product.
Figure 47: Clean the paper pick roller Allow the rollers to dry for 10 to 15 minutes. Please by R. If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. Please advise and thanks in advance for your help by Anonymous on Aug 28, 2004 at 12:40pm Add comment Please sign in to comment Same problem here.
i've had to resort to networking the printer for the 2 pc's and share folders between the 2 just to print. Figure : Insert the cartridge Close the cartridge latch. Lift the top cover. both resume and power lights flash, and no printing possible. - no information in the manual ,and nothing I do will correct it.
TIA - Anonymous 0 If you refill cartridges before they run dry, then the chances of burning out a heating element in the nozzles are minimal.My philosophy is to refill them The self-test report prints. Use both hands to pull whole sheets of paper to avoid tearing them. Make sure that the power cord is connected to the wall outlet.
http://www.windowsbbs.com/showthread.php?t=45561 suggested the kind of workaround I note below.